Purpose of a hopper with hydraulic bottom:
The device is used for storage and automatic feeding of chips. At the bottom of the hopper is mounted a movable frame, driven by a hydraulic cylinder. It pushes the chips to the chipboard of the auger. A sensor monitors the level of chips in the hopper and turns on the movement of the cylinder.
Operating conditions
The facility is designed to operate under the following conditions:
- Altitude: up to 2000m;
- Ambient air temperature: from 0ºС to 35ºС;
- Operating temperature of the oil: from 40 C, ° C to 75 °
- Humidity: from 20% to 90% (at 20ºC);
- Operating mode: S1-continuous;
- Electromagnetic environment: industrial;
- Supply voltage: 380 ± 5% at a frequency of 50Hz ± 1%.
Instructions for operation of a hydraulic bottom hopper
- During installation, a place must be provided for access to the electric motors of the equipment.
- Before putting the equipment into operation, the unobstructed operation of the electric drive motors must be checked and ensured.Copyright
- The operation of the hopper with a hydraulic bottom is done by connecting it to the power supply received by the control module.
- The operation of the hopper with a hydraulic bottom is stopped by disconnecting it from the power supply received by the control module.
- In case the operation of the equipment is not necessary for a longer period of time, then it is recommended to perform its emptying and cleaning.
GENERAL RULES:
1. Always follow the manufacturer's instructions and these safety instructions.
2. The use of the machine is only permitted after reading the operating instructions and after the relevant instruction.
3. The personnel servicing the facility must have the necessary qualification, be appointed by order of the employer, instructed and trained in the issues of safety, occupational hygiene and fire protection.
4. This machine is not intended for use by persons (including children) with limited physical and mental abilities, or with insufficient experience and knowledge, unless they have been observed or instructed in the use of the machine by a person responsible for their safety.
5. Any interference with the operation of the vibrating screen, which would endanger the health of the service personnel or other indirectly related persons, is inadmissible.
6. The vibrating screen must not be started if there are damaged mechanical parts or without protective covers.
7. Keep all covers and covers in place at all times.doll's pram
8. Make sure there are no people near the equipment before moving or operating the vibrating screen.
9. Keep your hands, feet, and clothing away from moving parts.
10. Turn off the power to the vibrating screen before adjusting, servicing, clearing jams, or performing other operations.
11. If a fault occurs in the vibrating screen, it must not be operated until the fault has been rectified and the machine has been properly operated.
12. The installation and commissioning of the vibrating screen must be carried out by persons trained and authorized by the manufacturer.
13. Do not change anything in the construction of the machine, fully comply with the preliminary design of the manufacturer.
14. When repairing, use only the spare parts specified by the manufacturer.
15. It is mandatory to comply with all regulations for fire protection.
Company "Hydroionics“Awaiting your inquiries for a hydraulic bottom hopper at phone or through e-mail.
* The facility is intended only for storage and transportation of chips. Do not use other types of materials than recommended. The user is fully responsible for damages caused by improper use!
family holiday
